Suche Produkten
or Series Ceiling, Wall Mount Bracket Kit
AP Access Point Ceiling Wall Mount Bracket Kit-spare
AP Access Point Ceiling Wall Mount Bracket Kit
Series Ceiling, Wall Mount Bracket kit- Spare
Power Injector for AG, AG, AG Series
This mount permits the Yagi antenna to be mounted to a flat surface or a mast, and then be adjusted in both horizontal and vertical angles.
Power Injectr AP Series
2.4 Ghz, 21 dBi Solid Dish Antenna w RP-TNC Connector
Mast-mount outdoor high-gain antenna with a RP-TNC connector. This antenna was designed for WLAN applications for frequencies of to MHz. The antenna is omnidirectional and has a nominal gain of 12 dBi. This design uses an elevated center-feed to produce an elevation pattern with very littl
Ceiling-mount indoor omnidirectional antenna with three cables terminating in RP-TNC connectors. For use with n access points. For use in the - to -MHz frequency band. The pigtail cables are plenum rated and 36 in. long each.
Indoor outdoor wall or mast mounted dual band omnidirectional antenna with 4 plenum-rated, 36-in. cables and RP-TNC connectors. Designed for use with access points having dual band ports such as , or .
Wall-mount indoor outdoor antenna with two RP-TNC connectors. Similar to AIR-ANTP-R, but providing diversity antennas in the same package for areas where multipath problems exist. The pigtail cable is plenum rated and 36 in. long.
2.4 GHz, 13 dBi directional antenna with two orthogonally polarized ports. Antenna comes with two 30-in. cables terminated in right angle N-type connectors.
Cisco Wireless Controller Rack Mount Bracket
Single gray dipole antenna with an RP-TNC connector. The antenna provides indoor omnidirectional coverage and is designed for use in the MHz frequency band. It does not articulate as the other dipole antennas. It can be used with all radios that utilize an RP-TNC antenna connector
Series Wireless Controller for up to 100 Cisco access points
Wall-mount diversity patch antenna with RP-TNC connectors. Designed for use in both indoor and outdoor applications. It comes with wall-mount hardware and has a gain of 7 dBi. It has a plenum-rated pigtail cable of 36 in.
Ceiling Mount Omni-directional Antenna - Designed for use indoor, this antenna comes with ceiling mount hardware. It has 6 plenum rated pigtail cables, 18 in. each, with 6 RP-TNC connectors.
Indoor-only gray, non-articulating dipole like omnidirectional antenna for 5 GHz. It can be used with radios that utilize an RP?TNC antenna connector.
Series Wireless Controller Redundant AC Power Supply
Supports both 2.4 GHz and 5 GHz operation with RP-TNC connectors. Provides lightning and related energy surges at the antenna from reaching the radio circuitry. A ground ring is included.
Single white dipole antenna with RP-TNC connector. The antenna provides indoor omnidirectional coverage. It has a 90-degree articulation radius and can be used with the access points.
Ceiling mount indoor antenna with two RP-TNC connectors. Supports diversity antennas in a single package for areas where multipath problems exist. The pigtail cable is plenum rated and 36” long.
Single white monopole antenna with RP-TNC connector. The antenna provides indoor omnidirectional coverage and is designed for use in the MHz frequency band. It does not articulate as the other dipole antennas. It can be used with the and access points.
Wall- or mast-mount 2.4-GHz indoor outdoor omnidirectional antenna with three cables terminating in RP-TNC connectors. For use with n access points. The pigtail cables are plenum rated and 36 in. long each.