Chromakeyer und bedien panel Ultimatte 8
Ultimatte 8 Chromakeyer und bedien panel live blue / green screen und viel mehr das bedien panel hat einen kratzer auf dem disply THE REAL ONE AND ONE OF THE BEST CHROMA - KEY DEVICE This unit comes with the mainframe and the control panel and allows analog RGB In-/and Outputs (see pictures of the rear) ich hab leider nur die ultimatte 7 bedienungs anleitung gefunden auf wunsch sende ich ihnen die zu ihrer mailadresse The ULTIMATTE-7 is a digital video image compositing device designed to produce realistic composites of two images. Its inputs and outputs comply with CCIR-601 Serial Component Digital standard. ULTIMATTE-7 can be interfaced with any video source that can provide or accept 8 or 10 bit serial digital video, such as video cameras, video recorders, telecines, video switchers, paint and graphic systems, etc. ULTIMATTE-7 is a real time digital device which differs from all keyers in the degree of realism it can achieve in a composite under various non-ideal conditions. There are a number of factors which can affect the realism of a composite image. Some of them depend on the sophistication of the compositing device, and others are determined by production techniques including art direction and lighting. The following section describes some of the factors that affect the natural and realistic look of a composite. 1.1 Naturalistic Edge: The appearance of the outer edges of the foreground (FG)(subject in the composite image is perhaps the primary factor affecting the believability of the composite. Nothing will undermine the illusion faster than colored fringing or dark lines or loss of detail on the edge of the foreground. A cut-and-paste look may be desirable in certain styles of graphics, but it can not be accepted in a composite which is intended to be a realistic image intercut with conventional images. A large segment of this manual is devoted to explaining the controls and techniques used to preserve the natural appearance of the FG subject. The MATTE DENSITY, GREEN DENSITY, RED DENSITY, BLACK GLOSS, BG LEVEL BALANCE, CLEAN UP LEVEL, CLEAN UP BAL., AND CLEAN UP THSHLD (threshold) controls can all affect the appearance of the edges of the FG subjects. Edges can also be affected by two other important factors: lighting and edge enhancement. If there is no side lighting on the FG subject, the edges can appear inappropriately dark in the composite image. It is important to remember that bounce light from the backing (screen) which is falling on the edges of the FG subject will be suppressed by the FLARE SUPPRESSION circuitry in the ULTIMATTE-7. To the eye the edges of the FG subject may appear to be illuminated because of the bounce from the angebote hier